Chemical Cold Vulcanizing Fluid , High Temperature Resistant Rubber
CMX5000 is mainly used in high temperature resistant conveyor belt
joint at cement, steel, coking,
metallurgy industries. After vulcanizing in normal pressure and
temperature, rubber belt can be worked
with light capacity in 1 hour. The belt can run at full capacity
after 6 hours at - 35-150 ℃.
ER-55 hardener is a kind of special rubber adhesive splicing
hardener, which can accelerate the
neoprene rubber, natural rubber, polyurethane adhesive splicing
speed, improve the adhesive
According to different adhesive, add 5% to 12% of the total
adhesive, it is widely used in all kinds of
conveyor belt cold vulcanized adhesive.
|Peeling strength (N／25mm)||After adhesive 30 mins≥100||After adhesive24 hours≥180|
|Shear strength (MPa)||After adhesive 30mins ≥2||After adhesive 24 hours≥3.5|
CMX5000 vulcanizing cement:
1. Strong adhesive function;
2. High temperature resistance;
3. High efficiency, Easy operation;
4. Safety of flame retardant;
5. Used combine with ER-55 hardener according to10:1 (1kg:100g).
|160805||CMX5000 adhesive||grey black||1kg||10tins/box|
1. Surface treatment: Polish the conveyor belt or fabric with steel wire wheels
uniformly, must not
wounded with fabric;
2. Wash: Wash the surface with CMX360 cleaner carefully until without any
3. Drying: Natural drying or heating drying;
4. Mixture: Mixing the adhesive and ER-45 hardener by 10:1, and used up within
When you want to use, you can mix for use.
5. Coating Adhesive: Coating Adhesive need 3 times. Each coating should be thin and
when the adhesive dry and not glue the hand, please coating the adhesive
6. Splice: After the last glue dry and not glue the hand, but good adhesive
force, splice is ok.
When you splice, please notice the center line of the conveyor
belt, two bonding surface
should be matched one time. After splice, beat it tightly from
middle to around.
7. Seal process: Use LPT918 for processing of the joint. Polish and Brush Seams
with the rubber
adhesive and natural drying. After mixing the rubber adhesive and
hardener, use it in
the joint seams quickly and let it smooth.
1. Polish the bonding surface and cleaning.
2. When used for rubber-metal bonding, should polish metal surface,
cleaning,and brush metal primer.
3. Mixture adhesive and hardener,brush two times; after first time
dry, then brush second time, bonding it
after second time slightly sticky, Compaction, driven out of the
bubble(if the second time brush is dry,
then can brush one more time).
4. Mixture ratio: adhesive:hardener=100:5
5. Should be used out within 2 hours if mixture
6. Also can be used for pulley lagging, conveyor belt joint, repair
and so on.
01) Q: Normal delivery time?
A: About 15 working days. If we have the store, the time will be
02) Q: Whether can visit your workshop to see how to process the
A: No problems, you are always welcomed to visit us.
03) Can I be your agent in our area?
A: Yes. ComiX is looking for the agents all over the world. If you
are interested , please feel free to contact
us to negotiate the agency mattes in details.
04) Q: How to get more informaition?
A: Please visit www.comixvulcanizer.com or www.comixvulcanizing.com