Seal Grey Cold Vulcanizing Fluid , Quick Dry Conveyor Belt Repair
1. Working temperature: higher than 10°C
2. Humidity:less than 90%
3. After base adhesive and the hardener mixed, it should be used
out within two hours.
4. In order to ensure the bonding quality, please test before use
5. Avoid contact with skin while using it.
6. Used combine with ER-45 hardener according to100:4 (1kg:40g)
CMX3000 is suitable for cohesion of rubber-rubber, rubber-metal,
rubber-fabric & fabric-fabric.
It has superb performance to be used for repair of conveyor belt,
cold splicing of conveyor ends, pulley
lagging ect. Same with SC2000.
ER-45 hardener is a kind of special rubber adhesive for splicing
hardener, which can accelerate the
neoprene rubber, natural rubber, polyurethane adhesive splicing
speed, improve the adhesive
temperature resistance and water resistance.
According to different adhesive, add 2% to 8% of the total
adhesive, it is widely used in all kinds of
conveyor belt cold vulcanized adhesive.
|Peeling strength (N／25mm)||After adhesive 30 mins≥120||After adhesive24 hours≥200|
|Shear strength (MPa)||After adhesive 30mins ≥2.5||After adhesive 24 hours≥4.0|
1. Keep out of the sun, Water resistance, damp-proof, Seal, dry
conditions in storage.
2. Construction site must maintain good ventilation
|160801||LPT3000 adhesive||grey black||1kg||10tins/box|
|160802||ER-45 hardener||canary yellow||40g||10tins/box|
1. Surface treatment: Polish the conveyor belt or fabric with steel wire wheels
uniformly, must not
wounded with fabric;
2. Wash: Wash the surface with LPT360 cleaner carefully until without any
3. Drying: Natural drying or heating drying;
4. Mixture: Mixing the adhesive and ER-45 hardener by 100:4, and used up
within two hours.
When you want to use, you can mix for use;
5. Coating Adhesive: Coating Adhesive need 3 times. Each coating should be thin and
when the adhesive dry and not glue the hand, please coating the
6. Splice: After the last glue dry and not glue the hand, but good adhesive
force, splice is ok.
When you splice, please notice the center line of the conveyor
belt, two bonding surface
should be matched one time. After splice, beat it tightly from
middle to around.
7. Seal process: Use CMX918 for processing of the joint. Polish and Brush Seams
with the rubber
adhesive and natural drying. After mixing the rubber adhesive and
hardener, use it in
the joint seams quickly and let it smooth.
01) Q: Normal delivery time?
A: About 15 working days. If we have the store, the time will be
02) Q: Whether can visit your workshop to see how to process the
A: No problems, you are always welcomed to visit us.
03) Can I be your agent in our area?
A: Yes. ComiX is looking for the agents all over the world. If you
are interested , please feel free to contact
us to negotiate the agency mattes in details.
04) Q: How to get more informaition?
A: Please visit www.comixvulcanizer.com or www.comixvulcanizing.com